Oz Guard N95/P2 Black Respirator Mask 10 Pack

Oz Guard N95/P2 Black Respirator Mask 10 Pack

General Information

Product: P2/N95 Respirator
Quantity: 10 Pieces Per Box

Made in Australia

- Product Code: SM-SR201GO/10
- ARTG: 347410 
- AS/NZS 1716:2012 P2
- BS EN 149:2001 FFP2 NR
- With Ear Loop

Warnings

SINGLE USE ONLY
WARNINGS
DO NOT touch the inner surface of the respirator. DO NOT use if the packaging is damaged. DO NOT use in highly toxic atmosphere. DO NOT use when oxygen is less than 19.5% and in explosive atmospheres. If breathing becomes difficult or dizziness occurs, return to an area where you can safely remove the respirator. Facial hair may reduce the effectiveness of the respirator, as it may not form an adequate seal on the face. Failure to follow all instructions, could reduce the effectiveness of this respirator and may result in sickness or death.

Directions

* Wash your hands thoroughly before and after putting on a respirator.
* To work as intended, a mask needs to fit your face properly. To ensure the correct fit:
        A. Separate the edges of the mask to fully open it.
        B. Bend the nose clip to form a gentle curve. The nose clip represents the top of the mask.
        C. Hold the mask upside down to expose the two ear loops.
        D. Using your index fingers and thumbs, separate the two ear loops.
        E. While holding the ear loops cup the mask under your chin.
        F. Hold the mask by both ear loops and place one loop over each ear.
        G. Gently conform/press the nose piece across the bridge of your nose by pressing down with fingers until the fit is snug.
        H. Continue to adjust the mask until you feel you have achieved a good and comfortable facial fit.
* Hold both of the ear loops and gently lift and pull the mask away from you and away from your face.
* Discard immediately according to local policies and procedures. Perform hand hygiene.